Your shopping cart is empty!
T: +44 (0)2476 214442
E: SALES@REPCO-TECH.CO.UK
Repco Technology Ltd.
"Number Three"
Siskin Drive
Middlemarch Business Park
Coventry
West Midlands
CV3 4FJ
Telephone: 02476 214442
Email: sales@repco-tech.co.uk
Features
Single and Double Acting Pneumatic Actuators
Namur VDI/VDE 3845 and ISO 5211 connections on all sizes. No special blocks are required to mount solenoid valves, limit switches or positioners.
The standard angle of rotation is 90Åã. Additional travel rotations of 120°, 135°, 150° and 180° are available. PD/PE 15 and upper sizes feature a travel stop wit ±10° in both open and close directions. Other angles (e.g. 30°) are optional.
The female pinion drive is standard with a double square output drive, and optional with a double-D drive, keyed drive and designs to meet your specific requirements.
Shaft bearings isolate the pinion gear from the housing and support the shaft for high cycle applications.
Ambient temperature: -20 °C to +80 °C (optional -40 °C to +150 °C).
The pinion teeth are engaged for the full length and stroke of the piston.
The pinion height allows manual override without disturbing the indicated positions.
External open/close indicator is standard, available indicators for all rotations.
Pistons incorporate double wear pads to separate the rack from the actuator wall and serve as both guide and wear bearings.
PD/PE series pistons feature a keyway as anti-blowout system.
All internal and external components are treated to increase corrosion resistance.
Epoxy coated special steel springs are pre-loaded.
The stainless steel end cap fasteners are extra long to allow for spring relaxation (PE only).
Air pressure operation from 2 to 10 bar (40–150 PSI). Water, nitrogen and compatible hydraulic fluids may also be used to power the actuator.
All external fasteners are corrosion resistant stainless steel.
All units are permanently lubricated at the factory with non-silicone grease.
All units are externally stamped with a progressive traceable serial number.
100% of all units are factory pressure leak tested.
.png)
